Hall Research HR-4P User Manual
Page 8
Model HR-4P Programmer
8
IR Codes
IR code‟s can be part of the configuration string. Supported IR formats are available for sending known IR Addresses and
Commands. Ensure that the IR Protocol, Address and Commands have been tested to ensure proper response from the
controlled devices. A compatible IR Emitter is required to send IR Codes.
CIR-EMT
Select the desired Condition and change Action to IR. When done, the user clicks the Add button to append the
command as shown in Figure 6.
Figure 6
– IR Code
If you know the IR Protocol and the command for the device you want to control, then all you have to do is to select
the protocol (like RC5, NEC, JVC, etc) from the dropdown list and enter the address and command (for example
Hall Research uses NEC protocol for most of its Scaler products and we publish the IR codes!).
If you don‟t know the IR protocol or command for your device, or if the protocol is not supported, you can “Learn”
the desired IR codes and program them into the HR-4P. The “Learning” process is described later and required an
IR Detector/Receiver cable
CIR-DET-D2