Denon AVR-785 - Manual (Page 61)

15 LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s
power switch is off and with the power cord disconnected.
16 INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1 Switch off the unit using the main unit’s power switch.
2 Hold the following SPEAKER A button and B button, and turn
the main unit’s power switch.
3 Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
1, 2 2
Recalling preset stations
1 Watching the display, press the SHIFT button to select the
preset memory block.
SHIFT
(Main unit) (Remote control unit)
2 Watching the display, press the PRESET • (+) or ª (–) button
to select the desired preset channel.
ª • PRESET
(Main unit) (Remote control unit)
2 1
2
1
NOTE: Please make sure the “AUDIO” position of the slide
switch on the remote control unit.
61
ENGLISH