Denon AVR-785 - Manual (Page 29)

Power Amp Assignment
Setting the power amplifier assignment
• Make this setting to switch the power amplifier for the surround back channel to ZONE2.
• If ZONE2 is selected, the signal that selected at ZONE2 is output at “SURR. BACK/ZONE2” PREOUT terminals.
1 Select “Surround Back” to use as the surround back channel,
“Zone2” to use as Zone 2 out.
2
Press the ENTER or (down) button to switch the On Screen Display setting.
26 AMP S.BACK
Setting the On Screen Display (OSD)
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
• Sets the on-screen display’s display mode.
Mode 1: Prevents flickering of the on-screen display when there is no video signal.
Mode 2: Flickering is not prevented.
Use this mode if the on-screen display does not appear in the mode 1, as may happen according to the TV being used.
1 Select “ON” or “OFF”.
27 OSD ON
3
Press the ENTER or (down) button to switch the Auto Preset Memory setting.
2 Select the On Screen Display Mode.
Select the “MODE1” or “MODE2”.
29
28 OSD MODE1
ENGLISH