Hall Research UHBX-SW3-WP User Manual
Page 7
Hall Research
714.641.6607
Page 7
A
A
u
u
t
t
o
o
“
“
P
P
o
o
w
w
e
e
r
r
C
C
o
o
m
m
m
m
a
a
n
n
d
d
”
”
M
M
o
o
d
d
e
e
The wall plate can send power on/off commands to the display
automatically based on the presence of video.
When Power Command mode is set for automatic, then when the wall plate
detects video on the selected input it will issue an ON command to the
screen, and if there is no video being detected, an OFF command will be
issued after a user specified delay (default delay = 5 minutes).
You can enter the Auto Power Command mode either from the wall plate
or by using the USB GUI. From the GUI you can also lock the Auto Power
Command mode (so it will stay in that mode permanently). To enable Auto
Power Command mode first make sure the wall plate is on. Press and hold
the power button for 3 seconds. The red LED above the power button
will start blinking slowly. This indicates that the wall plate will
automatically send on and off commands to the display based on video
detection on the selected input. In this mode, pressing the power button
will not do anything.
If not locked from the GUI, you can exit Auto Power Command mode by
pressing and holding the Power button for 3 seconds. The red LED above
the Source button will stop blinking. Now you can manually turn the panel
on and off (and at the same time issue commands to the display).
I
I
R
R
E
E
x
x
t
t
e
e
n
n
s
s
i
i
o
o
n
n
The wall plate features an IR detector that can be used to extend IR to the
remote receiver. An IR blaster cable will be required to plug to the receiver
(Hall Research model
o
. In this way the user can
point the IR remote to the wall plate and control the display. It is important
that the IR light signal blasted from the IR emitter at the receiver is not
incident on the wall plate's IR detector, since that will create a positive
feedback runaway condition.