Hall Research UHBX-SW3-WP User Manual
Page 5
Hall Research
714.641.6607
Page 5
P
P
o
o
w
w
e
e
r
r
i
i
n
n
g
g
t
t
h
h
e
e
W
W
a
a
l
l
l
l
P
P
l
l
a
a
t
t
e
e
a
a
n
n
d
d
S
S
e
e
l
l
e
e
c
c
t
t
i
i
n
n
g
g
a
a
S
S
o
o
u
u
r
r
c
c
e
e
As shipped from the factory the wall plate is in full manual mode. This
means that you have to manually turn on the wall plate and also manually
select the input source you want displayed.
If you have defined a display Power On command, then the wall plate will
issue that command at the same time it turns on. So all you have to do is
press the power button on the wall plate once.
1.
Press the power button
2.
The red LED above the power button will turn on and also one of the
3 green LEDs next to the inputs will turn on to indicate which source
is selected
3.
To change input, press the SOURCE button. For each press the green
LED next to each input connector will successively illuminate.
To turn off the wall plate, press the power button. Again, if you have
defined a display Power Off command, the wall plate will issue the
command as it turns off.