Glow-worm Clearly Solar System - Manual (Page 5)

5
Intended use
The Fluropro solar control is a temperature differential
controller for solar DHW provision with a cylinder reheat
programmer for a supplementary boiler.
The control is suitable for controlling solar systems with a
collector array and a storage cylinder.
The Fluropro solar control can be used for controlling a
second collector array
If a second collector array is connected, an additional
collector sensor (available as an accessory) must be installed.
It is possible to determine the solar gain by using an
additional gain sensor (supplied with Glow-worm Clearly Solar
sets).
The Fluropro solar control is a state-of-the-art control which
has been constructed in accordance with recognised safety
regulations. Nevertheless, improper use can cause serious
or fatal injury to the user or others, and the appliance or other
property can be damaged.
The manufacturer or supplier is not liable for any damage
resulting from improper use.
The control is not suitable for outdoor use and must be
installed in a dry room.
1 Specification
14276
Documents
Please retain these instructions as well as any documents
enclosed, for future reference.
We accept no liability in case of damage due to the non-
compliance of these instructions.
Servicing
To obtain service, please call your installer or Glow-worm’s
own service organisation using the telephone number on the
inside front cover of this booklet.
Cleaning
You can clean the housing of the Fluropro solar control with a
damp cloth and a little soap.
NOTE: Do not use scouring or cleaning agents which could
damage the display.
Recycling
The Fluropro solar control comprises many recyclable parts.
The packaging and control shall not be disposed of with
domestic waste but according to the current regulations.
General Information