Glow-worm Clearly Solar System - Manual (Page 25)

25
Display Relay check/sensor values Test procedure
Low cylinder sensor value
Not used
Collector sensor value (array 1)
Collector sensor value (array 2 if applicable)
Gain sensor value
Table 1 Actuators and sensors (continued)
You can check the visual display by pressing again.
Diagram 6.1 Check visual display
With another press, the current version of the controller’s
software is displayed.
Diagram 6.2 Controller software version
You can exit the service/diagnostic level by pressing the
and buttons simultaneously.
Emergency mode
When the Fluropro detects an error, its basic display always
shows the error. If either the solar yield or reheating function
is possible, the controller carries out this function despite the
error.
6 Service / Diagnostics