Glow-worm Clearly Heat Pump 5 kW - Manual (Page 10)

0020111744_00 - 09/10 - Glow-worm
- 8 -
INTRODUCTION
3.2 Regulations
3.2.1 Statutory requirements
IMPORTANT
Where no British Standards exists, materials and equipment
should be fi t for their purpose and of suitable quality and
workmanship.
The installation of this appliance must be carried out by a
competent person in accordance the rules in force in the
countries of destination.
Manufacturer’s instructions must not be taken as overriding
statutory requirements.
Standards
On installing and commissioning the appliance you must adhere
to the technical rules, standards and provisions in effect at the
time.
Reminder of existing regulatory acts
- EC regulation No. 20372000 from the 29th of June 2000
This European regulation repeals regulation No. 3093/94
and presents the elimination schedules of CFC and HCFC.
It also deals with the collection of refrigerants, system leaks,
particularly systems containing more than 3 kg of CFC or
HCFC, as well as the minimum level of qualifi cation required
by the technicians.
- EC regulation No. 0842/2006 from the 17th of May 2006
regarding the containment, use, collection and disposal
of the fl uorinated greenhouse gases, the labelling and
elimination of the products and equipment containing these
gases, the restriction of use and banning of certain products
from the market, as well as the training and certifi cation of
personnel and companies operating in the activities targeted
by this regulation: refrigeration, air-conditioning, heat pumps
and fi re protection systems containing greenhouse gases.
3.2.2 Other regulations
Control of Substances Hazardous to Health
Under Section 6 of The Health and Safety at Work Act 1974, we
are required to provide information on substances hazardous to
health. The adhesives and sealants used in this appliance are
cured and give no known hazard in this state.
The refrigerant used in this appliance is R410a the use of which
is strictly controlled by F Gas regulation EN842/2006.
4 Recycling
i
The recycling of the packaging must be carried
out by the qualifi ed professional who installed the
appliance. The recycling of any refrigerant fl uid must
be carried out by a suitably qualifi ed refrigerant
engineer.
4.1 Appliance
Most of the appliance is made of recyclable materials.
This symbol indicates that this appliance must not
be disposed of with household waste, that it should
be selectively collected for energy recovery, reuse
or recycling.
• Take the appliance to an appropriate collection point for the
treatment, evaluation and recycling. The collection point
must accept appliances containing refrigerant fl uids for their
recovery via recycling either within the elimination centre or
by an authorised service provider.
i
By complying with this directive, you will contribute
to the preservation of natural resources and the
protection of human health.
4.2 Packaging
The competent person who installed the appliance must:
• Sort the waste so as to separate those which can be
recycled (cardboard, plastics...) from those that cannot.
• Dispose of the waste in compliance with regulations in force.
4.3 Refrigerant
a
The appliance contains R410A refrigerant.
The refrigerant should only be handled by an
approved specialist. Avoid all contact with skin
and eyes.
R410A fl uorinated greenhouse gases are contained within a
fully sealed system (Kyoto Protocol PES 1975).
Under normal use and conditions, the refrigerant is not
dangerous.
Prior to disposing of the appliance, the refrigerant must be
properly recovered in a container suitable for recycling.
The personnel approved for this recuperation must have an
appropriate certifi cation according to the regulations in force.