FeiYu Tech FY-DOS - Manual (Page 9)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected] Page 9
DoS support 4 installation Orientations(LOGO arrow to up, down left,right) default installation Orientation is the
level position, the side with logo is to up, the arrow in the logo is in the same orientation with the head of the plane. If
need change other installation orientation,you can through our DoS setting software.
Default installation Orientation:
DoS’s position
a) The DoS has an arrow printed on the top of it. Orientate the arrow towards the front of the craft (i.e. direction of
flight).
b) When installing, please keep the DoS horizontal and as close as possible to the "Centre of gravity" (COG) of the
aircraft.
（as the following diagram.）
c) Also should keep the DoS in the horizontal level when the plane steady and straight flight,especially for the plane
with attack horn.it will be better to bed hedgehopping of its back to keep it in a horizon level.
It may happen the following deviation problems if the installation has deviation. If it has a little deviation,
operator can leveling the plane by adjusted Remote Control stick under the stabilized mode.
Plane roll remains level when in Auto Stabilization Mode
Plane will roll to
the right when in
Stabilized Mode
Plane will roll to
the left when in
Stabilized Mode
DoS
Plane nose will pitch down when
in Auto Stabilization Mode.
Plane nose pitches up when
in Auto Stabilization Mode.
Plane pitch
remains level
when in Auto
Stabilization
Mode
DoS