EXFO PPM-350C PON Power Meter - Manual (Page 25)

PPM-350C 19
7 Managing Test Results
You can save up to 1000 results (FTTx or OPM) in your unit. You can recall this data
later according to the storage configuration you have set. It is also possible to delete
data directly from your unit.
If you prefer, you can also transfer your data from your unit to a computer using a
USB cable.
Storing Data
Using the Handheld Data Transfer (HHDT) application, you can set storage
configurations and then upload them to your unit using a USB cable. Refer to the
Handheld Data Transfer documentation for more information on uploading
configurations.
You can have configurations using the following modes selected by HHDT:

OLT and ONT IDs, with different locations.

Job, where the OLT and ONT are grouped with different locations.
To store data in OLT mode:
1. Press
to access the data storage menu. The data you have selected is
temporarily stored to allow you to enter further information.
2. Press to access the available OLT
values. The OLT name is displayed next
to the Loc. indicator.
3. Press to select the OLT and switch
to the ONT selection.
4. Press to access the available ONT.
5. Press to select the ONT and switch to the Loc
ID selection.
6. Press to access the available Loc. IDs.
7. Press to select the location or to exit the
storage mode.
The data is stored. The Store indicator is highlighted to
show that the operation is complete.
Store/
Select
OLT ID
number
OLT name
Next
Store/
Select
Next
Store/
Select
Next
Store/
Select