EXFO EXpert IP Test Tools - Manual (Page 31)

Test Setup
EXpert IP 25
Configuration (Traceroute)
Configuration (Traceroute)
From the Main Menu, tap Traceroute, and the Configuration tab.
Configuration

Source IP Address/DNS displays the Source IP Address configured in
the Interface tab (see Network Configuration on page 21).

Destination IP Address/DNS specifies the Destination IP Address/DNS.
A maximum of 63 characters are allowed.

UDP Port specifies the UDP port number where the packets should be
sent when UDP protocol is used: 10000 to 65535 (default is 33440).
UDP Port is not available when the Probe Type is ICMP.

Start Hop Count allows to enter the Start Hop Count: 1 (default) to
255.

Maximum Hop Count specifies the upper limit of the Maximum Hop
Count (TTL): 1 to 255 (default is 30).

Reply Timeout (ms) specifies the length of time to wait for each ICMP
response: 0 to 10000 (default is 5000).

DiffServ Code Point specifies the type of Service field according to the
diffserv code point (RFC 2474) in the IP header of the packets: 0
(default) to 63.

Probe Type choices are ICMP (default), and UDP.