ENMET MX-52 User Manual
Page 22
ENMET Corporation
MX52 C
ONTROL
18
5.4.3 Bock Diagram of Scrolling Programming Menus
NORMAL
DISPLAY
P
Programming
[Channel xx]
–
+
Programming
Simulation [Channel xx]
–
+
Programming
Copy [Channel xx]
–
+
Programming
Control Unit
–
+
Programming
Reprogramming
To program the whole configuration of a channel
(ON/OFF, range, alarm thresholds, etc...)
To artificially vary a channel measurement on:
- the display panel,
- the 4-20 mA current output.
To trigger the alarms (LED and relays) at the same time.
To copy the complete programming from one channel to another
(time saving)
To program the whole configuration of the
MX52 C
ONTROL
(language, slave number, etc.).
To transfer data, measurements and events, etc., from the unit to a
computer via the
MX52 C
ONTROL
RS 485 / J BUS output.