ENMET RECON Series - Manual (Page 7)

R ECON ENMET Corporation
5
4.3 Checking RECON Status
To activate the detector, press the P OWER button and hold for 3 seconds.
When the RECON has finished its start up sequence. Press UP and S ET buttons at the same time, the display will
indicate Temp., time, STEL & TWA levels(for toxic) and maximum level
4.4 RECON Operational Perimeters
In this menu, you can adjust: Time, Date, Change instrument password, Activate/Deactivate the audio associated with the
pushbuttons switches and Activate/Deactivate the vibratory alarm.
With the RECON activated, press and hold the UP and D OWN buttons at the same time until the display
RECON menu options press the D OWN button to scroll through the option.
D ISPLAY F UNCTION
Press S ET button to select
date and time adjustment
Use the UP and D OWN buttons to adjust display
and S ET button to accept and advance to next option
C
AUTION
: If you change the
password for the factory set
password 1270, record your new
password for future reference.
Press S ET button to select
the Change Password option.
Press the S ET button and
enter the new password.
Use the UP and D OWN
buttons to incroment digit.
Use S ET button to accept
digit and advance the cursor.
Will be displayed. Then press S ET button.
Will be displayed. Enter the Old password.
When the correct Old password is entered,
will be displayed.
Then enter the new password.
When the last digit is entered,
will be displayed. Re-enter the new password.
When the completed password is entered, the display will
show the date information.
Not Used
Press S ET button to select
Sound ON or OFF
Does Not affect Alarm Audio
Press S ET button to accept display indication or Use
the UP button to change. Then press S ET button.
Press S ET button to select
Vibration ON or OFF
Press S ET button to accept display indication or Use
the UP button to change. Then press S ET button.
To exit with out saving the option state change, press the P OWER button.
N OTE : using the UP button reverses the menu.