ENMET RECON Series - Manual (Page 3)

R ECON ENMET Corporation
1
1.0 Introduction
The RECON is a portable-single gas detector for detection of combustible or toxic gases. It is intended for detection of
combustible or toxic gas in commercial or industrial facilities to keep workers safe, and/or detect a potentially explosive gas
environment.
The RECON , adopting excellent-quality sensor, makes detection in the way of natural diffusion. It has good sensitivity and
reproducibility. The detector adopts embedded MCU controller, easy to operate.
The RECON incorporates a special high strength, anti-slip rubber case providing anti slip handleability.
The RECON has an ingress protection rating of 65.
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the RECON and examine it for shipping damage. If such damage is observed, notify both ENMET customer service
personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in
good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase Order and Sales
Order numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage,
usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a written
request to
ENMET Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days of
receipt at the following address:
Items included with the RECON
Instrument
Charger
Screwdriver
Manual
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the RECON is received as ordered. Each RECON
is labeled with its target gas. If there are accessories on the order, ascertain that they are present. Check the contents of
calibration kits. Notify
ENMET customer service personnel of any discrepancy immediately.
1.3 Serial Numbers
Each RECON is serialized. These numbers are on tags on the equipment and are on record in an ENMET database.