Elenco 3 1/2 Digit with Temperature - Manual (Page 8)

Table 4. Function Rotary Switch Symbols (continued)
Function Press Button
About press function button refer to Figure 4.
Figure 4. Function Press Button
1. SELECT (state choice)
There are several functions at one rotary switch position; press the
SELECT button to select the desired function: ~V,
Ω Ω
,
µµA~, mA~,
A~ range for AC or DC voltage, AC or DC current, resistance,
diode, or audible continuity measurement.
2. RANGE (range selection)
With the power on and the meter on the auto range mode, press the
RANGE button to select the desired measurement range manually.
The range goes from minimum to maximum by pressing the
RANGE button multiple times, and returns to minimum after
reaching the maximum range. Pressing and holding the RANGE
button for over two seconds returns the meter to auto range. This
button does not affect the frequency, capacitance, diode or
continuity range.
-8-
Position of Switch Function
O F Temperature measurement
µµA ~
DC/AC microampere current measurement
mA
~
DC/AC milliampere current measurement
A
~
DC/AC ampere current measurement
OFF Power off position