Elenco 3 1/2 Digit with Temperature - Manual (Page 14)

Measuring AC Voltage
1. Turn on the meter, then set up the meter to measure AC volts as
shown in Figure 7.
2. Insert the black test lead into the COM terminal and the red test
lead into the terminal.
3. Set the Function Rotary Switch to the ~V position and press
SELECT to select the AC voltage measuring mode (then,
“AUTO”, “AC” and “V” symbols are indicated on the display).
4. Connect the test leads to the circuit under test, then the
measured value is indicated on the display.
5. When measuring voltage less than 400mV, press the RANGE
button to switch to manual range mode and select the AC 400mV
range. Doing so will provide a better resolution for your
measurement.
6. You can press the Hz/DUTY button to read the signal frequency
or duty cycle under measurement from the display.
-14-