Echelon Lumewave CPD 3000 Lighting Controller - Manual (Page 3)

CPD 3000 Integration Guide iii
Welcome
Echelon’s Power Line based lighting controller, the CPD 3000, can be used to
control outdoor street lights which support proportional level control level control
using 0-10V or PWM control. In addition to control, the CPD 3000 collects vital
data such as run hours, voltage, current, power consumption, energy usage,
diagnostic alarms, and power factor. The information collected is shared through
communication on the AC mains. The CPD 3000 optimizes communications with
integrated power line meshing.
Smart Street Lighting with a CPD 3000 involves remotely collecting vital data
from the lighting controller (such as LED drivers, HPS ballasts, Induction
Generators) and communicating over the power lines with a Segment Controller
(Echelon SmartServer) which manages switching and dimming schedules, and
captures and forwards diagnostic alarms and energy consumption data to
operations monitoring servers over TCP/IP networking, including support for
GRPS or GSM wireless networks.
This document describes the hardware installation and wiring specifications for
the CPD 3000, plus the lighting controller interface. Because much of this
interface is derived from an outdoor luminaire resource file set that is used by the
LonMark organization, you can gain a full understanding of the scope of resource
files at the LonMark International web site, www.LonMark.org .