East Coast Supercharging ECS Paxton SC1500 '15 C7 Supercharger Kit - Manual (Page 43)

EASTCOASTSUPERCHARGING.COM n 609-752-0321
n 43 n
j j j j
n
On the driver’s side, install the supplied 1/2 inch OEM QC fitting and using the supplied 1/2 inch
hose, route under throttle body and behind the MAF wiring, as shown in Pictures 1 and 2. Route other
end to 3/4 inch hole on the air box (as drilled on page 9) shown in Picture 6 on the next page.
Picture 1 Picture 2
Picture 3
n
Dry sump oil system cars only: Locate the breather hose coming out of the dry sump tank and into
the passenger side valve cover. Cut small slit on the factory heat shrink hose where the arrows are
pointed in Picture 3 to release it from the barbs. Using the supplied 3/8 inch hose, factory “Y” block
and the 45-degree QC fitting from page 39 (Picture 2), vent both dry sump lines to the valve cover
fitting as in Picture 4 and 5. *Note: Take care to gently rotate the fitting on the valve cover to remove
and re-install.
*Dry sump oil
system cars only