Dynavector DV 507 tonearm User Manual

Page 2

Fig.1

3. Installation to turntable

For mounting the DV507 you will first require an accurately
placed hole in the deck. This can easily be obtained using
the enclosed paper template.

After marking the holes' center drill out to a diameter of 29 or
30mm. Test the arm in the mounting hole. Mark the position
of the DV507's small fixing holes on ARM BASE, remove the
arm and then make three small holes at these positions using
a gimlet or sharp instrument. The arm can now be secured to
the board using the screws provided.

CAUTION

There are no rubbers or felt
washers provided as these
detract from the
performance in todays
modern turntables.

Please keep the DV507 in
its box whilst drilling holes
to avoid any damage to the
arm. .

4. Output line connector

Insert the DV507's cable to the output terminal which is situated
under the DV507.

There will be a 2-5mm allowance between the plug and outer pipe of
the DV507 to enable you to use other types of lead should you wish
to do so. (See Fig. 2)

Fig.2

5. Cartridge installation and adjustments

Please follow these six points when installing your cartridge in the DV507.

1. Damper plate check
2. Overhang adjustment for the cartridge in headshell.
3. Main weight balance position
4. Tracking force setting.
5. Tone arm height adjusting
6. Bias adjustment.

These checks can be carried out as follows