Ditch Witch JT9 - Manual (Page 106)

JT9 Operator’s Manual
Systems and Equipment - 105
Tracker Control
CMW
®
Troubleshooting Tip: If thrust and rotation are not enabled:
• Check whether the green tracker control
light (shown), located on drilling unit
anchoring console, is on. If it is,
communication has probably stopped
between tracker and display, or tracker is
set to incorrect code.
• If communication cannot be restored, install
tracker control key in drilling unit and rotate
clockwise. Green tracker control light will
go off. Thrust and rotation will function.
NOTICE: Tracker operator cannot disable
thrust and rotation from tracker if tracker control
key is installed in drilling unit and turned to the
disable position.
j40om055w.eps