Bonaire Reverse Cycle - Manual (Page 34)

Multi-Appliance Comfort Control
Page 34
Controls- Installation / Setup / Commissioning
COMMISSIONING CHECK LIST
G
ENERAL
† All equipment ordered by the customer is installed.
† The mains and control wiring are complete and the main switch and circuit breaker turned ON.
† All Controller functions for the appliance operate.
† All electrical, pipe and drain connections are to manufacturer’s specifications and the relevant local
and national codes.
† Operate the air conditioner for heating and cooling.
D UCTED R EVERSE C YCLE S YSTEM
† Outdoor unit is installed away from flammable and corrosive materials and fumes (i.e. pool
chlorine/petrol etc).
† The system has been leak checked and evacuated as per the installation instructions.
† All installer settable functions have been adjusted and set correctly.
† Indoor unit platform or suspension mounting is suitable as per the installation instructions.
† Indoor unit is level.
† Indoor unit drain/s have been checked and tested for flow and leaks.
† Outdoor unit foundation / platform are suitable as per the installation instructions.
† Outdoor unit is level.
† All clearances around the outdoor unit are to the manufacturer’s specifications.
† Check for abnormal noise or vibration during operation of both heating and cooling.
† Check that the noise, condensate drainage or air flow does not disturb the neighbors.
D UCTWORK
† All ductwork is completed to plan, correctly supported and airtight.
† Air distribution checked, dampers are adjusted and all outlets correctly adjusted and wiped clean.