Bonaire Reverse Cycle - Manual (Page 23)

Multi-Appliance Comfort Control
Page 23
Ducted Reverse Cycle
5. Setting the time to start the program: Using the ▼ or ▲ arrows
set the HOUR required and press ENTER. The MINUTES number
will flash. Using the ▼ or ▲ arrows set the minutes number
required. The time will now be set. Press ENTER to proceed.
6. Setting the operation parameters: Before accepting or adjusting
the temperature you can also set:-
• ZONE Requirements – i.e. which zoned areas do you want
to operate at this time period.
− Press and release the CLEAN FILTER/ZONE ABCD
button. ZONE A (or the current open zone) will flash
− Press ▼ or ▲ to go to the next zone. Press the
ON/OFF button to set a zone as open (ON) or closed
(OFF). Repeat to open or close more zones.
− Press and release ENTER to save your selections.
Now your air conditioner will operate only in your
selected zone during that time period.
• ECONOMY / BOOST - press ECONOMY/BOOST. The
display will first show ECONOMY. Press again and BOOST
is shown.
NOTE: 1) BOOST mode is only available during heating
only operation and will not be selectable if setting the
operating mode to HEATCOOL. 2) Consult your dealer to
see if the BOOST option is installed with your system.
7. Setting the Temperature: use the ▼ or ▲ arrows set the required
temperature. Press ENTER. The next PROGRAM period will
flash.
8. If next program is required to be OFF; repeat function steps 3 & 5.
The next PROGRAM will now be flashing.
9. If next program is required to be ON; repeat steps 3, 4, 5, 6 & 7.
After steps 3, 4, 5, 6 & 7 are completed the next PROGRAM
period will be flashing.
If you want to make corrections to what you've entered, press SET
TIME/PROGRAM twice and you'll start the programming sequence
again. Scroll through the program selections by pressing the ENTER
key and change any items as you come to them.
If at any stage in programming mode you want to revert to the factory
default settings, remove the batteries (RF model only) or turn the power
off to the unit for hardwired controls and the settings will be as they
were before you started.