Bonaire Reverse Cycle - Manual (Page 30)

Multi-Appliance Comfort Control
Page 30
Ducted Reverse Cycle
YOUR AIR CONDITIONER WILL NOT OPERATE !
Question Y/N Solution
Yes Refer to question 4
1. Has the unit been run
since installation?
No Check that the main switch is turned ON, Check and replace the
batteries in the controller (RF Handset Only).
Yes Refer to question 3
2. Is the unit installed in a
new home?
No Refer to question 4
Yes Refer to question 4
3. Has the installer run the
unit?
No Check that the unit is turned ON at the main switch. Contact your
dealer to commission the unit.
Yes Press the reset buttons or turn the unit off then on to reset unit. If
the unit still does not start call for service. (refer to solution 6 for
reset instructions) NOTE: Remember your system is fitted with a
start-up and changeover delay timer to prevent compressor
damage.
4. Is the controller set to
operate in the correct
mode and is the SET
TEMP higher or lower
than the room
temperature?
No Follow the instructions in ‘USING YOUR COMFORT
CONTROLLER – GENERAL OPERATION’ located at the
beginning of this manual and set the controller correctly.
Yes The air conditioner may be programmed to be OFF. To operate
the air conditioner manually press the Manual / Auto button until
the MANUAL is displayed. Adjust the room SET TEMP as
desired.
5. Is the controller in
program mode?
No Refer to question 4
Yes Reset the unit. This can be done by:
1. Following the RESET procedure on ‘Page 28’, or,
2. Turn the appliance Off, then ON at the unit power isolator
6. Is RESET showing on
the controller display?
No Unit should operate normally. If not contact your authorised
Climate Technologies service provider.
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER TO
THE WARRANTY SECTION OF THIS BOOK