AMT Datasouth M7 - Manual (Page 67)

Page of 73 67
LCD panel is dark and
LEDs are lit on, but
The label is feeding
forward
* The LCD panel harness connector
is loose.
* The LCD panel harness connector is plugged
upside down.
Ribbon encoder
sensor doesn’t work * The ribbon encoder sensor
connector is loose.
* Fasten the connector.
Ribbon end sensor
doesn’t work
* The connector is loose.
* The ribbon sensor hole is covered
with dust.
* Check the connector.
* Clear the dust in the sensor hole by the blower.
Peel sensor is not
working
* Peel sensor is not located on the
correct position.
* The connector is loose. * Make sure that the media goes through the Peel
sensor.
* Plug the connect cable correctly.
Cutter is not working
* The connector is loose. * Plug in the connect cable correctly.
Label feeding is not
stable (skew) when
printing
* The media guide does not touch the
edge of the media.
* If the label is moving to the right side, please move
the label guide to left.
* If the label is moving to the left side, please move
the label guide to right.