AMT Datasouth M7 - Manual (Page 35)

Page of 73 35
3.1.1.1 Speed:
Use this option to setup print speed. The available print speed is between 4~12 ips
and each increament/decreament is 1 ips. The default print speed is 6 ips.
Press
key to raise the print speed, and press key to decrease print
speed. Press key to set it into printer. Press key to cancel the
setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the SPEED command, which will overwrite the setting set from the
front panel.
3.1.1.2 Density:
Use this option to setup printing darkness. The available setting is from 0 to 15, and
the step is 1. Printer default density is 8.You may need to adjust your density based
on selected media and ribbon type.
Press
and to increase/decrease the printing darkness. Press
key to enable the setting. Press key to cancel the setting and
return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the DENSITY command, which will overwrite the setting set from the
front panel.
3.1.1.3 Direction:
The direction setting value is either 1 or 0. Use this option to setup the printout
direction. Printer default printout direction is DIRECTION 0.
Press
key to set the direction as 1, and to set it as 0, and
key to enable the setting. Press key to cancel the setting and return to
the previous menu.
Print Setup 1/12
> Speed
Density
Direction
Speed
6
Print Setup 2/12
Speed
> Density
Direction
Density
8
Print Setup 3/12
Speed
Density
> Direction
Direction
0