AMT Datasouth M7 - Manual (Page 47)

Page of 73 47
B-3 Pre-Printed
This function can set the paper length and gap size before auto-calibrate the
sensor sensitivity. It can to get the sensor sensitivity accurately.
When enter [Pre-Printed] option, you will see following message. Please
complete there steps
Paper Len.
00812 dot
1. Press the button to move the cursor from
Left digit to right digit, and press the button to
set the value from “0” to “9” and the “dot/ mm/ inch”.
Press the
button to set the paper length into
the printer.
Bline Size
0024 dot
2. Press the button to move the cursor from
Left digit to right digit, and press the button to set
the value from “0” to “9” and the “dot/ mm/ inch”. Press the
button to set the bline size into the printer.
Bline Mode
Pre-Printed
3. Then, printer will feed labels to calibrate the sensor
sensitivity automatically. When calibration is completed, the
LCD screen will return to the previous menu.
Bline Mode 3/4
Manual
> Pre-Printed
Exit