Alwarerc Streak 1000 OctoCopter Kit With APC Props - Manual (Page 7)

4 Assembly Steps – Motor and ESC Soldering
Step 1.
You will received 8 motors in ALS1000CB. Step 2.
For the new motors, Thread Lock must be applied to
the two M3 Set Screws which is pre-inserted in the
motor.
(This is a must for safety flying.)
Step 3.
Install the Porp Mount to the motor using 3pcs M3
Hex Cap Screw.
(Apply little amount of Thread Locker
when assembly metal to metal parts.)
Step 4.
Double check the prop mount which must be installed
to the motor securely.
1.) Solder Black and Red AWG wires to the ESC.
2.) Solder 3pcs 3.5mm Bullet Connectors (Female) to
the ESC.
3.) Connect Servo Extension Wire to the Signal
Connector of ESC and secure it using Adhesive Tape.
7