Alwarerc Streak 1000 OctoCopter Kit With APC Props - Manual (Page 18)

5.4 Assembly Steps – Bipod Landing Gear.
Step 1.
Insert the Landing Gear Skid into the mounting hole of
Carbon Fiber Leading Gear Assembly. (Tips: You can
rotate the Landing Gear Skid into the hole with less
effort.) Step 2.
Adjust the length of the Landing Gear Skid. Each side
of the Landing Gear Skid should be about 195mm.
Step 3.
Secure Landing Gear Skid onto the Carbon Fiber
Leading Gear Assembly using the M3 Set Screw
which is pre-installed on the Landing Gear Skid Metal
Mount. Step 4.
Repeat Step 1-3 to complete another side of Bipod
Landing Gear Assembly. (Remarks: Two set of Bipod
Landing Gear Assemblies are not exactly the same
but is in symmetry direction.)
18