Alwarerc Streak 1000 OctoCopter Kit With APC Props - Manual (Page 13)

Step 21.
Install the Landing Gear Frame Assembly onto the
Lower Main Frame using M3x10mm Screws from step
7.
(Apply little amount of Thread Locker to the screws
before installation.)
Step 22.
Secure the Booms.
Step 23.
Secure the all Booms using the pre-installed M3
screws on the Motor Mount Assemblies.
(Make sure
all 8 Booms are completely secured.)
Step 24.
Perform Part 6. Quick Collapsible Illustration
shown bellow as to check the folding mechanism of
for arms.
13