Alwarerc Streak 1000 OctoCopter Kit With APC Props - Manual (Page 11)

Step 17.
Close view of the Motor Mount Assembly Installation
on the Lower Main Frame. Make sure the installation
is same as above. Step 18.
Insert the Battery Power Cable and Signal Wire of the
ESC into the Carbon Boom Arm. Same for all 8pcs
ESCs.
Step 19.
Solder the Battery Power Wires of the ESC to the
ESC Board. (Red wire = +ve , Black wire = -ve) Step 20.
Solder 2 pairs Battery Cable to the Large Current
Power/ESC Board and connect the other end to the
Battery Connectors. (Red = +ve , Black = -ve)
Do not
short circuit two polarities!!
11