ADLINK iSeries Monitor 18/21 - Manual (Page 23)

Introduction 11
TPZ-1300
1.5.3 Reset Button
The reset button is used to perform hard reset for the TPZ-1300.
1.5.4 VGA Connector
The TPZ-1300 provides one VGA connector for display on exter-
nal (D-sub 15P) monitor.
1.5.5 DVI-D Connector
The TPZ-1300 provides one DVI-D connector for display on an
external (DVI-D) monitor.
1.5.6 USB 2.0 Connectors
The TPZ-1300 provides a total of six USB 2.0 ports using Type A
USB connectors, with four ports on the front and two on the rear
panel. All are compatible with Hi-Speed, full-speed, and low-speed
USB devices. All USB ports share one EHCI controller, and two
USB ports share one UHCI controller. The TPZ-1300 supports
multiple boot devices, including USB flash drive, USB external
hard drive, USB floppy, USB CD-ROM and etc. The boot priority
and boot device can be configured in BIOS setting.
1.5.7 Compact-Flash Port
The TPZ-1300 is equipped with a Type I Compact-Flash socket on
the front panel. The CF interface provides +3.3V voltage to the CF
card, is transferred from SATA by an ASIC, and can act as an
alternative storage device for system installation. The TPZ-1300
can be booted up via a CF card with OS installed. When the CF
card is used as the boot device, it must be installed before system
NOTE: NOTE:
The high impedance of long VGA/DVI cables negatively affects
video signal integrity at the receiver side.
It is recommended that VGA/DVI cables be less than 2
meters in length with effective shielding, such as UL
style 2919 AWM. If video transmission distance is to
exceed 10 meters, a VGA/DVI signal repeater or active
KVM may provide better results.
.