ADLINK cPCI-6510 - Manual (Page 15)

Overview 1
cPCI-6510
1 Overview
1.1 Introduction
The cPCI-6510 Series is a 6U CompactPCI single board computer
in single slot width (4HP) form factor supporting 32nm Intel®
Core™ i7 SV, LV, ULV processors with integrated graphics and
ECC memory controller onboard. The cPCI-6510 provides up to
8GB of dual channel DDR3-800/1066 ECC memory soldered
onboard and implements the Mobile Intel® QM57 Express Chipset
to provide a full feature set and optimal performance per watt.
The cPCI-6510 Series provides a 64bit/66MHz CompactPCI bus,
up to two PMC sites with 64-bit/133MHz PCI-X bus supporting
rear I/O (PIM), and one PCI Express x8 XMC site (shared with
inner PMC site). Featured I/O includes four PCI Express Gigabit
Ethernet ports (two on front panel, two for PICMG 2.16), two USB
ports and a CompactFlash socket. DVI-I, COM and additional USB
ports are available on the cPCI-6510V version which also provides
a SATA connector for an onboard 2.5” SATA HDD. Optional Rear
Transition Modules provide versatile additional I/O including two
additional GbE, USB, COM, High Definition Audio, and storage
interfaces such as SATA, SCSI, and SAS with RAID support. The
cPCI-6510V supports dual independent display via two DVI or one
DVI and one VGA when accompanied by the appropriate Rear
Transition Module.
For flexibility of use, the cPCI-6510 Series can be installed in a
standard CompactPCI system slot as system master, or peripheral
slot as a PCI device. Through hardware switch setting, the
cPCI-6510 optionally supports operation in system or peripheral
slots as a standalone blade. The cPCI-6510 Series is ideally
suited for military, aviation, communication and other industrial
applications.