ADLINK aTCA-N700 - Manual (Page 25)

Switch Manager API Programming Guide
25
PARAMETERS
cmd [IN] Port attributes to be set;
RETURN
See the description of status_t in Section 1.
adlink_port_filter_mac_add ()
adlink_port_filter_mac_del ()
PROTOTYPE
status_t adlink_port_filter_mac_add (adlink_mac_entry_t *entry);
status_t adlink_port_filter_mac_del (adlink_mac_entry_t *entry);
DESCRIPTION
These functions are used to add and delete MAC filter entries. MAC filters will filter ingress
frames with specific source/destination MAC addresses on specific ports.
PARAMETERS
entry [IN] The MAC entry to be filtered;
RETURN
See the description of status_t in Section 1.
adlink_port_statistic_get ()
adlink_port_statistic_clear ()
PROTOTYPE
status_t adlink_port_statistic_get (UINT32 port, adlink_portstat_t *stat);
status_t adlink_port_statistic_clear (UINT32 port);
DESCRIPTION
The function ‘get’ is used to get statistics of a port, including count and rate in both byte unit and
packet unit. The function ‘clear’ is used to reset all counters.
PARAMETERS
port [IN] The port id;
stat [OUT] Statistics data will be filled in this structure;