3DLABS Wildcat II 5000 - Manual (Page 25)

Software Configuration
3Dlabs Graphics Accelerator Card User's Guide 29
3. On the Wildcat Monitor Display Properties dialog box, click Configure Monitor to change
the display mode, select a monitor type, and change the resolution/refresh rate. Once you
have made the changes you require, click OK to accept the new configuration and dismiss
the Configure Monitor dialog box. You are returned to the Wildcat Monitor Display
Properties dialog box.
4. In Windows 2000, click OK on the Display Properties dialog box to accept the changes. In
Windows NT, you must return to the Settings page, then click OK to accept the changes.
5. Reboot the workstation if you are prompted to do so. Most changes will take effect without
rebooting.
Note: See Appendix A, Specifications, for a list of available monitor resolutions.
See Enabling Stereo Display in this chapter for instructions on changing the Display Mode.