Datalogic Scanning C-BOX 200 - Manual (Page 21)

INSTALLATION
2
They are used together and they have the following significance:
when a jumper is in the J1 position (see Figure above) pin 40 is connected to pin 27
(EXT TRIG+); a jumper in J2 position connects pin 20 to pin 28 (EXT TRIG-).
If the jumpers are removed pin 20 and pin 40 are disconnected.
2.5 9-PIN INTERNAL CONNECTOR
The scanner auxiliary serial interface available on the internal 9-pin connector can be
used either for configuration through WinHost or for data monitoring.
The details of the connector pins are indicated in the following table:
Figure 14 - 9-pin male connector
9-pin connector pinout
Pin Name Function
1 N.C.
2 RXA Auxiliary RS232
3 TXA Auxiliary RS232
4 N.C.
5 SGND Signal Ground
6 N.C.
9 N.C.
DS2100A - DS2400A
7 CTSA Auxiliary Handshake RS232
8 RTSA Auxiliary Handshake RS232
DS4600A
7 SGND AUX Auxiliary Signal Ground
8 GND Ground
13