Denso BHT-7500 - Manual (Page 125)

105
Chapter 2. Getting Started the BHT and System Mode
BHT-7500W
SET TRANSMIT KEY
1:TRANSMIT KEY
KEY1 KEY2
KEY3 KEY4
SET TRANSMIT KEY
1:TRANSMIT KEY
KEY1 KEY2
KEY3 KEY4
Set up?
1:Yes
2:No
Setting TRANSMIT KEY
Selecting the "5:TRANSMIT KEY" on the WEP KEY
definition screen displays the "** Now Loading
**." After that, the screen shown at left will ap-
pear.
Select a desired item by using the numerical keys
or
and keys.
For details about the TRANSMIT KEY, refer to Sub-
section 3.1.2.
Pressing the C key will display the confirmation
screen as shown at left.
To save the new entry, choose "1:Yes" and press
the ENT key. The "** Now Setting **" will appear
and the screen will return to the WEP KEY defini-
tion screen.
To cancel the new entry, choose "2:No" and press
the ENT key. The newly entered data will be
discarded and the screen will return to the WEP
KEY definition screen.
When the "** Now Setting **" is displayed,
the new entry will be written onto the
EEPROM of the wireless module built in the
BHT-7500W.
While this message is displayed, do not turn
the BHT off. Writing halfway onto the
EEPROM will not bring any assured settings.