Avanti BD555 - Manual (Page 9)

INSTALLATION INSTRUCTIONS
Installation Of CO
2
Cylinder Support
• Install the metal support provided onto the 4 studs located on the exterior back wall. Align the
holes in the support with the studs and push down firmly. {See Figure 1)
Installation Of CO 2 Cylinder
• Install your fully charged cylinder into the support stand.
installation Of CO
2
Regulator
• Attach the CO 2 regulator to the cylinder by turning the regulator nut onto cylinder valve,
making sure washer is securely inserted into connecting nut. Tighten snug using an
adjustable wrench and assure there are no leaks. (See Figure 2)
Installation Of CO
2
Air Line Hose To Regulator
• Attach one end of the air line (red) hose provided to the hose connection on the regulator.
• Secure hose by using one of the two clamps provided. Use pliers to tighten clamp and assure
no teaks. (See Figure 3)
Installation Of CO
2
Air Line Inside Cabinet
• Remove plug located at the exterior back (top left hand corner).
• Save it for later use if you decide to convert unit to an ail refrigerator.
• Insert the open end of the air line (red) into the cabinet through the uncovered hole. (See Figure 4)
Installation Of The Beer Tower
• Remove the top plug by twisting and puliing out, saving it for later use if you decide to convert unit
to an all refrigerator.
• Unravel the beer line (hose) from the tower and insert the beer line and wing nut through the
uncovered hole on top.
• Lock the beer tower assembly to the top and make sure to position the beer faucet so it is aligned
with the cabinet front (6 o’clock position). You accomplish this by aligning the bottom of the beer
tower to the 3 grooves on the top cabinet and tighten by hand clockwise to properly lock.
• Plastic faucet lever: see explanation and skectch on page 10.
Installation Of Protective Metal Plate
• This plate should always be installed when the keg stand is in place to protect against
unnecessary damage to the floor of the cabinet.
Fi« 1 Fig. 2 Fig.3