Avanti BD555 - Manual (Page 13)

FIGURE 1 (Position prior to door reversal) FIGURE 2 (Position after door reversal)
1 Upper Pin
2 Pin Cap
3 Inner Plug
4 Lower Door Hinge
5 Washer
6 Bolt-pin
7 Leveling Legs
8 Door Hinge Screws
Cleaning Your Beer Dispenser
• Turn the temperature control to "OFF", unplug the Beer Dispenser, and remove the contents.
• Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves and stand with a mild detergent solution.
• The outside of the Beer Dispenser should be cleaned with mild detergent and warm water.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts. ■
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
Vacation Time
Short vacations: Leave the Beer Dispenser operating during vacations of less than three weeks.
Long vacations: If the appliance will not be used for several months, remove all contents and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly; blocking it open if necessary.
Moving Your Beer Dispenser
Remove all the contents.
Securely tape down all loose items inside your Beer Dispenser.
Turn the leveling screws up to the base to avoid damage.
Tape the door shut.
Be sure the Beer Dispenser stays secure in the upright position during transportation. Also
protect outside of Beer Dispenser with a blanket, or similar item.
12