Avanti BD555 - Manual (Page 8)

Dispenser not to perform properly.
Avoid locating the Beer Dispenser in moist areas.
After plugging the appliance into a wail outlet, allow the unit to cool down for 2-3 hours before
placing any contents in the Beer Dispenser compartment.
Electrical Connection
X Warning V
Improper use of the grounded plug can result in the risk of electrical shock, if the power cord is
damaged, have it replaced by an authorized Avanti Products service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize
the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord
supplied.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
Use of extension cords is not recommended.
This appliance requires a standard 115/120-volt, 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not let exposed or dangling to prevent
accidental injury.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Warning
CO
2
GAS CAN BE DANGEROUS
WARNING: CO 2 cylinders contain high-pressure compressed gas which can be hazardous if not
handled property. Make sure you READ and UNDERSTAND the following procedures for CO 2
cylinders BEFORE INSTALLATION.
1. ALWAYS connect the CO 2 cylinder to a regulator. Failure to do so could result in explosion
with possible death or injury when the cylinder valve is opened.
2. NEVER connect the C02 cylinder directly to the product container.
3. ALWAYS follow correct procedures when cylinders are changed.
4. ALWAYS secure the cylinder in an upright position.
5. NEVER drop or throw a C02 cylinder.
6. ALWAYS keep a CO
2 cylinder away from heat. Store extra cylinders in a cool place
(preferably TO^F). Securely fasten with a chain in an upright position when storing.
7. ALWAYS ventilate and leave the area immediately if CO 2 leakage has occurred.
8. ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over five (5)
years, do not use, return cylinder to gas supplier.
9. NEVER connect a product container unless there are two (2) safety’s in the pressure system:
a. One at or on the CO 2 regulator
b. One at or on the product coupler or in the pressure gas line.