Directed Electronics AM1 - Manual (Page 26)

24 © 2003 directed electronics, inc.
to exit the learn routine:
Do one of the following:
1. Close the open door.
2. Turn the ignition on.
3. No activity for longer than 15 seconds.
4. Press the integrated LED/Valet ® switch too many times.
on-board dual stage shock sensor
There is a dual-stage shock sensor inside the control module. Adjustments are made via
the rotary control as indicated above. Since the shock sensor does not work well when
mounted firmly to metal, we recommend against screwing down the control module. The
full trigger of the onboard shock sensor reports zone 2. See Table of Zones.
N NO OTTEE:: When adjusting the sensor, it must be in the same mounting location that it will
be after the install is completed. Adjusting the sensor and then relocating the module
requires readjustment.
Less Sensitive More Sensitive