Disarming without a 2-way remote – Directed Electronics 130XV User Manual

Page 24

1. First press any button on the remote to clear the alarm page.

2. Press either the

button again and the High

Security disarm feature will be activated. The siren will be

silenced and the system will reset to the armed state.

3. Pressing the

button once more will fully disarm the

system and allow the vehicle to be accessed.

disarming without a 2-way remote

If your 2-way remote is lost or damaged, you can manually

disarm your vehicle security system. To disarm the system

without a 2-way remote, you must have the vehicle's ignition key

and know where the Valet

button is located. Be sure to check

with your installer at the time of installation for both the location

and the preset response (1-5 presses) of the Valet

button.

To disarm the security system,

turn the ignition to the ON posi-

tion. Press and release the Valet

button the preset number of times

DRW-35

➜

notes: The first press of the remote button, while the
remote is beeping, only clears the alarm page (no com-
mand is sent to the vehicle).

The transceiver transmits immediately upon system trig-
ger and does not allow disarm during the first 6 seconds
after trigger.

The 2-way remote will respond with a number of beeps
and LED flashes according to whether a pinswitch, sen-
sor, activated the alarm (and also if NPC is active).