Care and maintenance, To clean the cabinet, To clean the heads and tape paths – Aiwa LCX-350 User Manual
Page 19: Care of discs, Care of tapes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

GENERAL
CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and-dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution. Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
To clean the heads and tape paths
After every 10 hours of use, clean the heads and tape paths
with a head cleaning cassette or cotton swab moistened with
cleaning fluid or denatured alcohol. (These cleaning kits are
commercially available.)
When cleaning with a cotton swab, wipe the recording/playback
head, erasure head, capstans, and pinchrollers.
Care of discs
• When a disc becomes dirty, wipe the disc from the center out
with a cleaning cloth.
CO
o_i
UJ<
ztr
ZlU
82
a:«
lU
• After playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
Care of tapes
• Store tapes in their cases after use.
• Do not leave tapes near magnets, motors, television sets, or
any source of magnetism. This will downgrade the sound
quality and cause noise.
• Do not expose tapes to direct sunlight, or leave them in a car
parked in direct sunlight.
After cleaning the heads and tape paths with a liquid head
cleaning cassette or a moistened swab, wait until the cleaned
parts are completely dried before inserting the tapes.
ENGLISH
1
8