Aiphone MY-CB - Manual (Page 2)

^ INSTALLATION
If camera angle is not changed, proceed with installation,
following steps O ? 0 > O ^nd ® only.
® Remove a screw cover, pulling from the bottom notch. Loosen
tamper-proof screw with the supplied screwdriver.
(2) Attach the back frame to SINGLE-GANG BOX or to wall
with the supplied screws or wood screws.
(3) Pull the tamper screw, and push CALL button, and remove the
front case from the MY-CB ¡main unit.
0 Connect wires on 2 terminals.
Attach the main unit to back frame.
0 Insert the supplied screw to temporarily hold the main unit to
back frame.
® Unscrew at 2 points to open the camera cover.
Take away the camera lens fixer(will not be reused).
@ Change the camera angle, pushing arrow part.
Be careful not to touch the lens surface.
The camera gearing sound is heard, but this is not an unit
disorder.
0 Reattach the camera cover.
Be careful that the weather-stripping rests in place.
@ Loosen the temporary holding screw.
Reattach the front case to the main unit, until it locks.
® Fasten the tamper screw and attach the cover.
MY-CB UNIT
BACK FRAME siNGLE-GANG BOX
fl MY-C
BACK FRAME .
? TAMPER SCREW (2)
SCREW SCREW
83.5^
(3-5/16") SCREW
COVER
Push strongly
CALL button.
Pull strongly
tamper screw.
WEATHER­
STRIPPING
LENS
FIXER
CAMERA
COVER
BACK FRAME
Changing camera
lens angle;
UPWARD
SCREW (2)
TEMPORARY
HOLDING SCREW
SCREW (2)
DOWNWARD
for exposed (*) Indicates panned direction,
cable run. when viewing on the monitor,
SPECIFICATIONS
*Power source: Supplied by MY-IBD or main video monitor.
*Camera unit: CCD (Charge-Coupled Device) with infrared LEDs.
^Scanning line: 525 lines.
*Image viewing area: Vertically: approx. 51cm (1'.8")
Horizontally: approx. 72cm (2'.5")
*Camera angle adjustable: Upward: approx. 14.5°
Downward: approx. 11.5°
To each left or right: approx. 12°
*Minimum illumination: 1 lux or less (at 50cm/20" distance)
*Dimensions (H x W x D) & weight: 132 X 100 X 47.5 (mm) (5-1/4" x 4" x 1-3/4"). Approx. 300g (0.66 lbs.)
^T
*For further information, refer to the Instructions furnished with main room stations.
TO MAINTAIN PROPERLY
Clean MY-CB unit with a soft cloth dampened with neutral household cleanser. Never use lacquer thinner or benzine, etc.
Be careful with the camera cover, as it could be scratched.
Do not splash water to MY-CB door station by hose, etc.
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of
one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective
upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make
the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the
warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation
of instructions furnished, nor extended to units which have been repaired or altered outside of the factory.
This warranty does not cover batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
Aiphone Co., Ltd., Nagoya, Japan
Aiphone Corporation, Bellevue, WA, USA
MY-CB-I (E) 1192C
COMMUNICATION SYSTEMS
AIPHONE
HOME. BUSINESS, INDUSTRY.
Printed in Japan (E)