Aiphone TB-ADM10 - Manual (Page 8)

TECHNICAL PRECAUTIONS
Video recording
• TB-ADM10 has CN9 video output connectable to a local Monitor TV or VCR (525 line only) with
coaxial cable. Record video on VCR,(no audio) It is not an automatic recording.
• When a Time-Lapse VCR is connected with additional non-polar b, b wires to VCR’s control
terminals, all images on MYH-CU can be recorded automatically, (no audio)
Transfer of MY door call
It is not possible to transfer a call of MY or lE/IF door station. If TRANSFER switch is
wrongly pressed, hang up TB-M handset, and press TRANSFER switch to clear.
Monitoring
For visual monitoring (any MY), always use MONITOR button on TB-ADM10.
To monitor lE/IF, press a designated button, lifting TB-M handest. TB-SE sub can never be monitored.
SPECIFICATIONS
Power source:
Current consumption:
No. of door stations.
Call-in timer:
Video timer:
Auto-scanning timer:
Wiring:
Wiring distance:
18V DC. Use a PS-18C or PS-18D power supply.
700mA max. (TB-ADM10 only)
10 (max.) either PanTilt MY or lE/IF Series door stations.
40 seconds
2-1/2 minutes
60 minutes
2 conductors, non-polarized per door station
6 conductors, TB-ADM10 to MYFI-CU
———___ Gauge
Distance —~
22AWG 18AWG
From TB-ADM10 to PanTilt MY 165' 330'
to MY-DS 330' 650'
to lE/IF audio 450' 1,180'
O.65mm0 1 .Ommo
50m 100m
100m 200m
150m 360m
Gauge
Distance ———
18AWG 16AWG
From TB-ADM10 to PS-18C or PS-18D 16' 33'
1 .Ommo 1. 2 mm 0
5m 10m
Dimensions (H x W x D): 92 x 195 x 230 (mm). 3-5/8" x 7-5/8" x 9"
Weight: 1.5kgs. (3.31 lbs.) approx.
This equipment has been tested and found to comply with the limits for a Class B digitai'device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equiprnent generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may causé harmful interference to radio communications. However, there Is no
guarantee that interference will not occur in a particular installation. If this equipmeht does cause harrhful inteference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or rnore of the following measures:
• Reorient or relocate the receiving antenna. • Connect the equipment; into an outlet on a circuit different from that to which the receiver is connected.
• Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help.
'•i*
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two
years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which
examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision
whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of
instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover
batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
♦ ‘*‘1* »1* ♦I*. ♦
•Î-
«I»
Aiphone Co., Ltd., Nagoya, Japan
Aiphone Corporation, Bellevue, WA, USA
TB-ADMIO-I(E) 0795F
© COMMUNICATION SYSTEMS
AIPHONE
HOME, BUSINESS, INDUSTRY.
Printed in Japan (E)
-
8
-