Aiphone TB-ADM10 - Manual (Page 5)

MOUNTING
• Desk-top mounting Wall-mounting
TB-ADM10
1. Remove 2 screws on front panel, removing 2 covers.
2. Lift off front case holding sides at top.
3. Disconnect TB-ADM10, plugging off connector.
4. Open a cable inlet hole (rubber part) on rear or bottom of chassis.
5. Pull in cable(s), and make wire terminations.
6. Use attached cable clamp(s) for neat and secured connection.
7. Reconnect and mount front case to chassis, attaching the covers to place.
★ For wall-mounting, the chassis must be mounted upside down.
When wall-mounted with TB-M (and TB-G)
Decide an exact location of TB-M master, and the next unit(s) atachedly mounts with the guides below;
TB-M master TB-G add-on TB-ADM10
selector
Wall-mounting guide Unit: mm
Master Attached Guide A Attached Guide B
TB-10M
TB-20G 202.5 TB-ADM10 172.5
TB-40G 277.5 TB-ADM10 247.5
TB-ADM10 225.0 — —
TB-20M
TB-20G 240.0 TB-ADM10 172.5
TB-40G 315.0 TB-ADM10 247.5
TB-ADM10 262.5 — —
★ Processing conductor end
5C-2V or
RG-59/U (20GA) 3C-2V or
RG-59/U (22GA)
11mm (7/16”)
3mm (1/8”)
li'v
Fold back
8.5mm (3/8”)