Aiphone TB-ADM10 - Manual (Page 6)

OPERATIONS
Pan and tilting MY camera
While MYH-CU monitor is on, pan and tilt the MY door camera.
Camera
tilts down.
Camera pans to right.
Receiving a call from MY door station
1. Press CALL button on MY door station.
2. Intermittent tremolo rings on TB-M. The LED is lit to indicate.
MYH-CU turns on. It times out in 40 seconds.
3. Pick up TB-M handset, and press a designated button.
4. Communicate. Image is alive for 2-1/2 minutes.
5. When MYH-CU turns off, press MONITOR button on
TB-ADM10 to resume.
6. At conclusion, hang up TB-M handset. MYH-CU turns off.
Calling an MY door station
1. Pick up TB-M handset, and press a designated button.
2. MYH-CU turns on. Pre-tone is heard at MY door station.
The channel is established. Call by voice.
3. Communicate.
When called by MY door station, while communicating
1. A call-in LED is only lit. Image on MYH-CU remains unchanged.
2. To reply, press an LED-lit button, and the image is switched.
Selective & handsfree audio/visual monitoring
1. On TB-ADM10, press MONITOR button.
The LED above is lit.
2. Within 5 seconds, press a designated
button of MY door station you wish to
monitor. The LED is lit.
3. MYH-CU turns on. Hear audio from
TB-ADM10 speaker.
4. To call, pick up TB-M handset.
When called by MY door station during visual
monitoring
1. Call-in LED is only lit, with audio call tone muted. The image is kept on,
2. Pick up TB-M handset. The channel to an MY door station being monitored is established.
3. Press a desinated button of calling MY door station.
4. Image of calling MY comes on. Communicate.
-
6
-