AEG MICROMAT 625 - Manual (Page 13)

First use
^ n*nn ^
u - u u _
I
MC 173
t- 1 n
Connect the appliance to the mains. The
display starts to flash.
MC 174
Use the +/- buttons to enter the hour
(7, in this example). Press the © but­
ton and enter the minutes (10, in this ex­
ample), Press the 0 button once
again. The time of day will appear in the
display. The appliance is now ready for
operation.
The time of day can be corrected by pressing the © twice
(and then proceeding as above).
p 0
MC 175
Press the © button. Then hold the
+/- button down until the required
length of time appears in the display (the
maximum is 99 minutes).
Press the S button. “P 9" will appear
in the display and the symbol ^ for
micro-wave will start to flash. Set “P 0" by holding the - button
down. The symbol for micro-wave will go out, and the 0 sym­
bol for the timer will flash.
When you press the start button the pre-set time will appear
in the display and count downwards in seconds.
When the time set on the timer comes to an end you will hear an
audible signal, which you can switch off by pressing the C but­
ton. The display now switches over to showing the time of
day.
Time of day/
short time
alarm
Time of day
Hours/minutes
Correcting
time of day
Short time
alarm
Starting
the timer
Note
13