Audiovox SP85 - Manual (Page 7)

2. If the handset is out of the cradle when ringing
starts, press |SND I to answer a call.
To Place a Call to a Number in the
Memory
1. Press [RCL I, then enter the memory address (01
through 50). The last ten digits of the number will
appear on the readout. If the number is longer
than 10 digits, hold down the second digit of the
memory address (after pressing IRCLI) to see the
prefix.
Also see Last Number Review Option.
2. PressfSNDl.Thel IN USE | indicator will light as
a call is placed. You may lift the handset from the
cradle either before or after the called party
answers to proceed with your conversation.
To Mute Phone Conversation
1. Press I FUNC I, then[^. The| Mutelwill appear
on the readout. Then the transmit audio will be
muted and the receive audio will be heard from the
loudspeaker. You may converse privately with a
passenger during a call with the handset either
“on-hook” or “off-hook”.
2. To return to normal conversation:
When not in the Hands-free Mode,
if “off-hook”, press! FUNC |, thenj 8 jagain,
if “on-hook”, lift the handset from the cradle.
When in the Hands-free Mode,
Press! FUNC I, then! 8 !again, or lift the handset
from the cradle.
3. Mute is reset when call is terminated.
CALL RESTRICTION
(NAM OPTION)
This feature permits you to impose various kinds of
restrictions on Outgoing Calls.
To Set Mode of Call Restriction
Enter three digit Security Code (assigned by NAM),
then press jFUNCi, key then [ 7 ].
The following key operation is needed to activate one
of the restriction modes;
[T1 i Only telephone numbers having 11
digits or less are accepted.
I 2 I : Only telephone numbers having 7
digits or less are accepted.
fS] i Operator assisted dialing (0
Origination) is prohibited.
[4] ■ No phone calls can be placed except from
repertory' memory address 01 to 09.
!~0l : No restriction.
To Exit Call Restriction Programming
Mode
Press !FUNCL then ICL^.
Note.
(1) When in 4 mode, number storage into the memory
will not be permitted.
(2) In the restriction mode, a short beep tone will be
heard to inform you of the wrong operation, and
the word !
Restricted ! will be shown on the
readout.
Call in Progress Protection
Phone conversation will continue after ignition is
turned off until call is terminated.
12 13