Audiovox SP85 - Manual (Page 5)

Example:
Press ISTOl, key [T]then [S], the displayed
number will be stored into memory address 15.
Note; In this scroll feature, any vacant memory
locations will be skipped.
To Recall a Number from Memory
Press [M, then enter the memory address (01
through 50).
Example;
Press I RCL I, key [T] then | 5 |, the number stored
in memory location 15 will be displayed.
If You Want to See the Prefix
(Number Longer than 10 digits)
After pressing [m, hold down the second digit of
the memory address.
Last number Review
Press |RCL|, key I 0 |th en [O] again, the last number
in the display returns.
Display Own Telephone Number
You can see your own telephone number on the
readout.
Press IRCLI. key 0, then 53.
Repertory Memory Scroll
This feature will be useful in finding a certain tele­
phone number by scrolling the repertory memory
from one of the designated starting addresses.
1. Press IRCLI, key I X I then [5] .
I X I is the digit to assign the starting address as
follows.
X Starting address
0 01
1 11
2 21
3 31
4 41
Press I# I or 0.
[#J : Scroll upward (with roll back to 01)
I ** I : Scroll downward (with roll to 50)
Memory address and the last seven digits of the
stored number will be displayed on the readout as
follows.
For example:|3|l| —|l|2|s|4|5|6l7 |
Address No. Tel. No.
Automatic Storing into the Vacant
Memory Address
This feature allows an automatic storing into the
vacant repertory memory address. This ends the
problem of writing over previous stored number.
1. Enter a telephone number.
2. Press I STO I
3. Enter the memory area which you want to store
number.
rOl: From 01 to 10
m: From 11 to 20
r2l: From 21 to 30
[33 : From 31 to 40
33 • From 41 to 50
I it I : From 01 to 50
4. Press [g]
Then the memory address and the last seven
digits of the stored telephone number will be
displayed on the readout as follows.
For example : ¡3| 11—11| 2|3|4|5|6| 7 j
If there is no vacant address in the assigned area,
telephone number will not be stored in the
memory.
To Lock the Unit
Press [FUNCI, then the numeral [T] (LOCK).
The
I LOCK I
indicator lights. The unit will remain
locked until unlocked, even if the ignition switch is
turned off.
Automatic Lock (NAM Option)
If you request it, your NAM can be changed and your
unit will automatically go into lock condition when
your ignition is turned “off”. When the key is turned
“on”, the unlock code is required to operate the
phone.
To Unlock the Unit
Enter the three digit unlock code. The indicator will
go out when three digits are the same as the
resistered code in NAM.
Backlighting Control
LCD display and the keypad will be backlit auto­
matically after the Switch-ON.