Audiovox SP85 - Manual (Page 6)

If needed, backlighting will be turned off by pressing
[RCQ,H then [^.
Even the unit is in the Backlighting-OFF mode, for
the duration of 10 seconds after any key operation
and when a call is received, backlighting will be
turned on again automatically.
To return to the Backlighting-ON mode, press |RCL|,
Q then again.
Volume Control
The audio level of the loud speaker, earpiece and the
alert tone can be adjusted by the Volume Control
Buttons ([ a ]and rvl).
•Loud Speaker: Leave the handset in cradle and
To increase — Keep pressing Button until you
get the moderate sound level.
To decrease — Keep pressing [V] Button until you
get the moderate sound level.
Sound level will be displayed on the readout digitally
during the level adjustment and the sample tone will
indicate the sound level when you are not engaged
in a telephone conversation.
Display format is as follows.
SPK □ □ (1 to 10)
•Handset: Lift the handset and perform the same
procedures as above.
In this case, the display format is as follows.
H-S □ □ (1 to 10)
•Alert Tone; Press iRCLl, key 0 then [^.
Then adjust the alert tone level in the same manner
as above. Your telephone will sound the associated
alert tone level by ringing.
In this case, the display format of the readout is
as follows.
ALTQ □(! to 5)
PLACING TELEPHONE CALLS
To Place a Call
1. Enter telephone number with the handset on-hook
or off-hook. The last fifteen digits of the dialed
number are displayed on the digital readout.
Note: After 120 sec., display will return to the 10
digit display mode.
2 . If a dialing error is made, press |CLR|, then________
enter the telephone number again. Pressing ICLR I
momentarily (less than approx. 0.5 sec.) clears the
last digit.
3. Press [SND]. Then IIN USE I indicator will light.
You may lift the handset from the cradle either
before or after the called party answers to proceed
with your conversation.
Note: If assigned in NAM, number can be pre-set
up to 32 digits. However, in this case, it is
necessary to confirm with the system
operator whether such service is available.
If the Call Fails to Go Through
1. If you hear the “reorder" signal, press |END|,
then if there were no dialing errors, press iSNDl
for redial. (Digit key re-dialing is not necessary.)
2. If the “intercept” signal is heard, hang up, then
redial the correct number.
Automatic Redial (NAM Option)
If selected, your unit will automatically make five
attempts to reach the cell site when the first try is
not successful. The ||N USE] indicator will stay on,
but the speaker will be muted for twenty seconds.
This is done so you do not hear the reorder signals
out of the speaker. If you wish to terminate the
automatic redial, press | END].
Terminating a Call (Hanging Up)
Press [END], or replace the handset in the cradle.
The I IN USEI indicator will go out.
If Hands-free is activated in NAM, you have to press
[END I key to terminate a call.
To Receive Calls
1. When the telephone rings, lift the handset to
answer. The IIN USEI indicator will light.
10 11